The racer asked
how do I set this up for Nor-Cal track?
Miles, So Dialed's RC setup AI
Nor-Cal’s name alone doesn’t tell me the surface or grip, so there isn’t one reliable track-specific setup. If you mean a low-grip clay layout, use these B7.1D settings as a starting point, then tune one change at a time:
- Front shocks: 32.5 wt oil with the 2.0 mm, 2x1.8 mm-hole pistons.
- Front caster insert: +5 degrees; Ackermann inner shims: 0 mm.
- Front shock tower: standard; keep the front shock mounts at mid.
- Rear shocks: standard direction and 0 mm eyelet length; use the -2 mm rear tower.
- Rear tires: the B7.1D clay setup data lists TZO tires with T1 compound.
These are starting points, not a confirmed Nor-Cal setup. If the track has good grip, these low-grip choices may feel too soft or lack steering precision. Is Nor-Cal’s track clay, carpet, or astroturf, and would you call the grip low, medium, or high?
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RC10 B7.1/B7.1D questions
How can I get more low-speed steering on a Team Associated RC10 B7.1/B7.1D?
For a sharper steering response at low speed, try KPI 3 if you’re currently at KPI 0. The B7 setup tips describe KPI 3 as the most direct steering feel, while KPI 0 is less...
What pill setting for wide C and D blocks on RC10 B7.1/B7.1D?
For a wide rear pivot on the B7.1/B7.1D, set the C- and D-block inserts to the positions that give the widest hinge-pin spacing, and mirror the left and right sides. There isn’t...
Which tires for a freezing-cold track on an Associated RC10 B7.1/B7.1D?
For a freezing-cold track, start with a soft or super-soft compound. Cold tires need a softer compound to conform to the surface and generate grip; the right tread still depends...
RC10 B7.1: 69T vs 72T spur with 17.5T motor — which is better?
A 69T spur gives taller gearing than a 72T spur with the same pinion: about 4.2% more rollout, so it can gain speed on a long straight. It also gives up some wheel torque, which...
Gearing for RC10 B7.1 with Hobbywing V10 G5 17.5T?
For the RC10 B7.1 with the Hobbywing V10 G5 17.5T Torque, start with a 31T pinion and the stock 78T spur. That gives a 6.54:1 final drive ratio; confidence is high for this...
Team Associated RC10 B7.1/B7.1D front and rear anti-roll bar set part numbers?
I can’t verify the front and rear anti-roll bar set part numbers from the B7.1/B7.1D information available here. It does list front bar diameters from 0.8 to 1.2 mm, but not the...
