Ask Miles, our Setup AI that’s been trained on the Intimidator 7 Direct Drive.
Stock gearing for the Custom Works Intimidator 7 Direct Drive, with common pinions and their ratios.
| Pinion | Spur ÷ pinion | FDR | Rollout |
|---|---|---|---|
| 18T | 4.33 | 4.33 | 49.7 mm |
| 19T | 4.11 | 4.11 | 52.5 mm |
| 20T | 3.90 | 3.90 | 55.3 mm |
| 21T | 3.71 | 3.71 | 58.0 mm |
| 22T | 3.55 | 3.55 | 60.8 mm |
| 23T | 3.39 | 3.39 | 63.5 mm |
| 24T | 3.25 | 3.25 | 66.3 mm |
| 25T | 3.12 | 3.12 | 69.1 mm |
| 26T | 3.00 | 3.00 | 71.8 mm |
| 27T | 2.89 | 2.89 | 74.6 mm |
| 28T | 2.79 | 2.79 | 77.4 mm |
| 29T | 2.69 | 2.69 | 80.1 mm |
Shaded rows are the pinions most 1/10 2WD late model setups run on the stock spur. Rollout at a 68.6 mm tire.
What pinion should I run?
Tell us your motor and track and get a starting pinion for the Custom Works Intimidator 7 Direct Drive, with the range racers in the class run.
Get a recommendation →Shop pinion gears at AMain → (opens in new tab)It depends on your motor and the track. Racers in the 1/10 2WD late model class run a 20–27 tooth pinion in most setups, usually on a 81T spur for a final drive ratio near 8.81. Hotter motors (lower turns, higher Kv) take a smaller pinion; tight tracks gear down, open tracks gear up. For a starting pinion matched to your motor, use the So Dialed Pinion Recommender with the Intimidator 7 Direct Drive selected.
The Intimidator 7 Direct Drive has an internal ratio of 1:1. Final drive ratio = spur ÷ pinion × 1. With the stock 78T spur, a 18T pinion gives an FDR of 4.33 and a 29T gives 2.69.
78 teeth. Changing the spur moves every pinion's ratio at once; most racers leave the spur and tune with the pinion.
Free to start · iOS & Android
Your Custom Works Intimidator 7 Direct Drive is in the RC Setup App
Save every setup change you make to your Custom Works Intimidator 7 Direct Drive, get AI tuning answers for that exact car, and log your races — at the track or back in the pits.

