The racer asked
How do I mount the servo on this car
Miles, So Dialed's RC setup AI
The SNRC R3-G/C/Pro setup information I have doesn’t show the servo’s exact mounting orientation or screw locations, so check the kit manual’s chassis diagram before fastening it. In general, install the servo in the chassis’ designated servo mount, then center and connect the steering linkage.
- Power the radio and receiver, set steering trim to zero, and center the servo.
- Secure the servo using the mounting hardware and any rubber grommets or spacers supplied with your kit. Tighten snugly without crushing the case.
- Fit the servo horn so it is as close to straight as possible with the wheels pointing straight ahead. Connect the steering link, then adjust its length for straight wheels.
- Turn the steering fully both ways and check that nothing binds; set radio endpoints so the servo does not strain against the steering stops.
The model data lists a Savox SC-1258TG as a servo used by other drivers, but it doesn’t specify how the servo mounts on the chassis. If you share a photo of the chassis or the manual’s servo-installation page, I can help identify the correct orientation.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
