The racer asked
caster block insert
Miles, So Dialed's RC setup AI
The B7/B7D caster block inserts provide 0°, 2.5°, and 5° positions. The kit baseline is -2.5° in the setup data; you may see the insert positions logged as 0°, -2.5°, and -5°. For less steering on entry and more on exit, try the 0° insert.
Follow-up
baseline should be +2.5 degrees
Miles
You’re right. The B7/B7D baseline caster block insert is +2.5°. I gave the wrong sign earlier.
Follow-up
what is the effect of using +5 degree caster block instead of +2.5 degrees
Miles
Going from +2.5° to +5° caster adds caster, so expect more steering on entry and less steering on exit compared with +2.5°. The B7 setup guidance points to 0° for less entry steering and more exit steering.
Try it as a single change and compare; the result can vary with track grip.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RC10 B7/B7D questions
What is a baseline indoor carpet setup for Team Associated RC10 B7/B7D?
For a Team Associated RC10 B7 or B7D, start with this indoor carpet baseline. I don’t have a verified EOS event-specific sheet, so treat these as carpet starting settings, not an...
What ride height for RC10 B7/B7D on smooth high-grip clay?
For a B7/B7D on smooth, high-grip clay, start at 17 mm front and rear. Racers commonly run about 16–18 mm at both ends on high-grip clay. Measure with the car race-ready on its...
What is a typical ride height for a Team Associated RC10 B7/B7D on high-grip clay?
For a B7/B7D on high-grip clay, a typical starting point is 16–18 mm front and rear. Drivers’ setups cluster around 16–18 mm at both ends, so try 17 mm front and rear first.
What springs do people use on high-grip tracks for Team Associated RC10 B7/B7D?
It depends on the surface. For high-grip carpet, the most common front spring listed is the 4.3 lb Orange; racers also use 4.0 lb Red and some stiffer aftermarket options. For...
