The racer asked
what springs do people use on high grip?
Miles, So Dialed's RC setup AI
It depends on the surface. For high-grip carpet, the most common front spring listed is the 4.3 lb Orange; racers also use 4.0 lb Red and some stiffer aftermarket options. For high-grip clay, I see 3.4 lb Gray, 3.3 lb White, and 3.6 lb Blue.
I don’t have a clear B7/B7D rear-spring trend to recommend. Is your track carpet or clay?
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RC10 B7/B7D questions
What is a baseline indoor carpet setup for Team Associated RC10 B7/B7D?
For a Team Associated RC10 B7 or B7D, start with this indoor carpet baseline. I don’t have a verified EOS event-specific sheet, so treat these as carpet starting settings, not an...
What caster block insert positions are available for Team Associated RC10 B7/B7D?
The B7/B7D caster block inserts provide 0°, 2.5°, and 5° positions. The kit baseline is -2.5° in the setup data; you may see the insert positions logged as 0°, -2.5°, and -5°. For...
What ride height for RC10 B7/B7D on smooth high-grip clay?
For a B7/B7D on smooth, high-grip clay, start at 17 mm front and rear. Racers commonly run about 16–18 mm at both ends on high-grip clay. Measure with the car race-ready on its...
What is a typical ride height for a Team Associated RC10 B7/B7D on high-grip clay?
For a B7/B7D on high-grip clay, a typical starting point is 16–18 mm front and rear. Drivers’ setups cluster around 16–18 mm at both ends, so try 17 mm front and rear first.
