The racer asked
What grease to use on front shocks and side springs. And what is a good ride height to star with
Miles, So Dialed's RC setup AI
For the ride height, start at 2 mm front and 2 mm rear. That is the typical starting value for a 1/24-1/28 small-scale 2WD touring or GP car, and the Atomic MFX is in that class. The kit setup doesn't list a front ride height number, so this is the baseline to start from. The class also lists a second starting point of 1.6 mm front and 1.8 mm rear, so you can try that if the car feels like it is sitting high at the front.
For grease, I don't have a specific recommendation for the Atomic MFX's front shocks or side springs. In general, a thin film of light shock grease on the shock shaft o-rings and the spring seats keeps the shaft sealed and the spring moving freely, while the oil itself stays the same. Keep grease off the piston and out of the oil. The kit front shock fluid is 30,000 cst, so if you're rebuilding the front shocks, keep that oil unless you're changing damping on purpose.
- Set the ride height first, then check that the front and rear shock springs compress and extend smoothly after you add grease.
- If the front end pushes on corner entry after a ride height change, the next thing to try is a lower front ride height, one step at a time.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
