The racer asked
grip for polished wood floor
Miles, So Dialed's RC setup AI
On polished wood you're on a slick, hard surface, so set up the Cougar LD3 M/S/D as a low-grip hard-packed track. That means raising the ride height at both ends and adding a little rear toe-in, starting from the kit setup.
- Front and rear ride height: 21 mm each (kit is 18 mm). Higher ride height keeps the car more stable over bumps and debris, which matters on a slick floor.
- Rear toe inserts: 4 degrees (kit is 3 degrees). More rear toe-in adds forward bite on throttle out of corners.
- Rear arm length: 1
- Short (kit is 2
- Long). The shorter rear wishbone gives more rear grip on slippery surfaces, but you'll need to soften the rear suspension to match.
- Front and rear camber: leave at -1 degrees, the standard value for this surface.
Watch for the car feeling tall or wallowing in the corners after the ride height change. If it does, drop the ride height back a mm at a time. If the rear starts stepping out on throttle, add a little more toe-in before changing anything else. If you're still losing grip, the tire compound will matter more than these settings.
Are you finding the car pushes on entry or gets loose on power? Tell me which one and I can narrow the changes.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More Cougar LD3 M/S/D questions
How do I increase mid-corner steering and reduce high-speed turn-in on a Cougar LD3 on carpet?
For the LD3, lower the front pivot block first: move its 1 mm spacer from below the block to above the link mount. This slightly calms initial steering while adding...
Best astroturf setup for Schumacher Cougar LD3 M/S/D?
For a medium-grip astroturf track, start with the LD3’s mid-astro setup: medium rear diff height, mid rear wheelbase, 1° front toe-out, and the kit rear toe setting of 3°. Use...
