The racer asked
What fdr should I be targeting with a 17.5t motor for stock racing
Miles, So Dialed's RC setup AI
Target 8.05:1 FDR as a starting point, using a 24T pinion with the TLR 22-4 2.0’s stock 84T spur. That’s a high-confidence recommendation for a 17.5T motor; the car’s stock spur is 84T.
The available data doesn’t provide a separate range for racers in this class, so treat 8.05 as your baseline and tune for your track and motor. Check motor temperature after a short run. If it’s too hot, drop one pinion tooth and recheck.
Follow-up
Because it’s only a 17.5t motor should I gear it for a lower fdr
Miles
No, don’t lower the FDR just because it’s a 17.5T motor. Start at 8.05:1 with the stock 84T spur and 24T pinion; that recommendation already accounts for the motor wind.
A lower FDR means taller gearing: more speed potential, but less torque and more motor load. Check motor temperature after a short run. If it’s too hot, go down one pinion tooth, which raises the FDR and reduces the load.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More 22-4 2.0 questions
What diff fluid for TLR 22-4 2.0 on hard-pack bumpy medium-grip?
For the TLR 22-4 2.0, start with 50,000 cSt in both front and rear diffs. If the car skips or feels unsettled over the bumps, try 40,000 cSt, changing one diff at a time, starting...
What fdr should I be targeting?
I need your motor’s turns or Kv to recommend an FDR target. The TLR 22-4 2.0 has a 2.3 internal ratio and an 84T stock spur, so its FDR is 2.3 × 84 ÷ pinion teeth. What motor are...
