The racer asked
Droop setting high traction carpet
Miles, So Dialed's RC setup AI
I don't have a droop number for the Rapide F1 EVO2 or the F1 class, so I can't give you a starting value. Start from the kit droop and change one end at a time based on how the car drives.
Droop here means how far the suspension can drop before it hits its stop, so more droop lets the rear pod drop further.
- Rear Suspension: Droop, more: helps when the rear is breaking loose or the car is traction-rolling on exit. On high-grip carpet, more rear droop often helps the rear bite on corner exit, which can reduce push.
- Rear Suspension: Droop, less: steadies the car at speed and reduces looseness on the way out of a corner, so use it if the rear gets snappy on the straights.
- Front Suspension: Droop: leave this alone at first. Changing it moves front grip, which affects steering more than traction.
Droop is track-dependent, so the right amount on high-grip carpet has to come from testing. Make one small change, then run several laps and compare. If you tell me whether the car pushes or gets loose on corner exit, and what your current rear droop setting is, I can narrow down the direction.
Miles
The material has no droop number for the Rapide F1 EVO2 or the F1 class, so I can't give you a starting value. The kit setup lists the droop settings without a value, and the class baseline doesn't include droop either. The general guidance is to move rear droop one step at a time and test the result on your track.
On high-grip carpet, the usual complaint is push (understeer) on corner exit, which is traction roll under load. Adding rear droop reduces that push and helps the rear hold on exit.
- Rear droop: move it toward more. This is the first change to try if the car pushes or rolls on exit.
- Rear droop: move it back toward less if the car feels unstable or wanders on the straights, since less droop favors high-speed stability.
- Front droop: leave it alone while you test the rear, so you can see the effect of one change.
Watch for looseness on corner entry after you add rear droop. If that happens, back off a step and try a lighter front or stiffer rear change instead. Because the material says droop depends on the track and only testing will tell, run a few laps after each step and note the lap times.
If you tell me the rear droop number on your car and whether it pushes or is loose, I can help you pick the next change.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More Rapide F1 EVO2 questions
What droop settings should I run on a Roche Rapide F1 EVO2?
There's no stock droop figure for the Rapide F1 EVO2, and I don't have a class baseline for droop either, so I can't give you a starting number. Droop is the amount the suspension...
What setup should I run on Roche Rapide F1 EVO2 for high-traction carpet?
Tell me which handling problem you're seeing and I'll give you one change for it. On high-grip carpet the car usually either pushes on corner entry or gets loose on exit, and each...
