The racer asked
Troop setting high traction carpet
Miles, So Dialed's RC setup AI
Tell me which handling problem you're seeing and I'll give you one change for it. On high-grip carpet the car usually either pushes on corner entry or gets loose on exit, and each has a different fix. Until then, the kit setup is the baseline: front camber -2.0 degrees, front caster 6 degrees, front toe -1 degree (out). The rear is a solid axle, so rear camber and toe stay fixed.
- Entry push (understeer): soften the front tire compound or harden the rear, and lower the front roll center. Lighter front shock springs also help.
- Loose mid-corner or exit (oversteer): harden the front tire compound or soften the rear, and stiffen the front shock springs.
- Wheelspin on exit: lighter shock oil or more/larger piston holes, and move weight bias toward the rear.
- Traction roll (body leaning and loss of grip mid-corner): lower ride height, stiffen the front springs, and harden the tire compound.
Watch out for changing several of these at once, because they interact. Change one, run a few laps, then decide on the next. Kit front caster is 6 degrees, and the F1 class baseline is 9 degrees, so caster is a valid thing to test if the front feels vague, but it affects entry and mid-corner in different directions.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More Rapide F1 EVO2 questions
What droop settings should I run on a Roche Rapide F1 EVO2?
There's no stock droop figure for the Rapide F1 EVO2, and I don't have a class baseline for droop either, so I can't give you a starting number. Droop is the amount the suspension...
What droop setting should I run on a Roche Rapide F1 EVO2 for high-traction carpet?
I don't have a droop number for the Rapide F1 EVO2 or the F1 class, so I can't give you a starting value. Start from the kit droop and change one end at a time based on how the...
