The racer asked
How to Slow down the Chassis
Miles, So Dialed's RC setup AI
To calm a quick, snappy RD2.0 and slow how fast it rotates, add rear grip. A car that swings its tail around too quickly is oversteering, and more rear grip makes it more stable. I'm assuming you mean the car is too eager to rotate in transitions and that you're running the kit setup.
Rear grip holds the back end in line, so the car turns more slowly and feels calmer on entry and through the middle of the corner. Softening or thinning the rear shifts grip there.
- Rear shock oil: Go thinner than the kit 50 wt. High grip carpet setups commonly run 150 cst at the rear.
- Rear toe: Add a little toe-in to steady the rear under power. Toe-in is positive.
- Rear springs: Soften them only if the rear still feels loose after the oil change. The kit spring is RD2.0 (#YS-RDS).
Too much rear grip makes the car push wide and fight the steering. Change one setting at a time. If it's still too quick, tell me whether it snaps on corner entry or on exit.
Miles
To calm a Yokomo RD2.0 that rotates too quickly, add rear grip and take a little front grip away so the rear holds before the front steers the car around. I'm reading "slow down the chassis" as reducing how sharply it swings. If you meant top speed, tell me and I'll look at gearing.
The car snaps around when the rear breaks loose before the front bites. Adding rear grip and softening the front's steering response makes the rotation more predictable.
- Rear shock oil weight: move thinner from the kit 50 wt. Thinner rear oil adds rear grip. Other racers on low-grip concrete run 15 wt at the rear.
- Rear toe: add a little toe-in for more rear stability.
- Front shock oil weight: move thicker from the kit 50 wt. Thicker front oil reduces front grip, so the car steers in less eagerly.
- Front toe: reduce toe-out slightly to calm the initial turn-in.
Change one setting at a time and make a short run after each. Too much rear grip makes the car push on entry, and too much front oil can leave it hard to turn in. If the car still rotates too fast after these changes, tell me how it behaves on entry and exit and I can narrow it down.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RD2.0 questions
Why does my Yokomo RD2.0 spin out and feel like ice vs my other RD2.0?
Spinning out and feeling like ice usually means the rear is losing grip on throttle, and the cause is most likely whatever differs between your two RD2.0s. Since you didn't say...
Will harder rear springs slow down my Yokomo RD2.0?
Stiffer rear springs won't meaningfully slow the car down. They change how the chassis loads and how much grip the rear tires have, not top speed. A stiffer rear spring reduces...
How much rear toe-in should I run on a Yokomo RD2.0 on low-grip concrete?
Start with about 1.5 degrees of rear toe-in, the value other RD2.0 racers run on low grip concrete tracks. The 1/10 drift class baseline also starts at +1 degree of rear toe, so 1...
What's the stock front alignment on a Yokomo RD2.0?
The RD2.0 kit setup data doesn’t specify a factory front toe angle. Assuming you mean toe, 0° (straight ahead) is the neutral baseline; the listed adjustment range is +3° to −5°.
Why does my Yokomo RD2.0 keep spinning out on P-tile?
If the rear is snapping around on P-tile, first confirm your tires are actually intended for that surface, then make one small increase in rear toe-in. More rear toe-in generally...
