The racer asked
How to set the Toe in the Rear
Miles, So Dialed's RC setup AI
Start with about 1.5 degrees of rear toe-in, the value other RD2.0 racers run on low grip concrete tracks. The 1/10 drift class baseline also starts at +1 degree of rear toe, so 1 to 1.5 degrees is a sound place to begin. Positive is toe-in and negative is toe-out.
Rear toe mainly changes how the car rotates on corner entry and through the middle of the corner. More toe-in plants the rear and adds stability, so it helps when the car is loose. Less toe-in frees the rear up, so it helps when the car pushes.
- Rear toe: if the car oversteers, increase toe-in in small steps of about 0.5 degrees.
- Rear toe: if the car understeers, decrease toe-in toward 0 degrees.
Set both sides to the same angle and change only one thing at a time. Rear toe is adjusted at the rear RF arm mount, which is 57.2mm in the kit setup.
Watch for too much toe-in. It scrubs speed off the exit, adds drag, and wears the rear tires quickly. If the car still oversteers at 1.5 degrees, move to a stiffer rear spring or thicker rear shock oil before adding more toe-in. Those change the rear grip more cleanly.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RD2.0 questions
Why does my Yokomo RD2.0 spin out and feel like ice vs my other RD2.0?
Spinning out and feeling like ice usually means the rear is losing grip on throttle, and the cause is most likely whatever differs between your two RD2.0s. Since you didn't say...
Will harder rear springs slow down my Yokomo RD2.0?
Stiffer rear springs won't meaningfully slow the car down. They change how the chassis loads and how much grip the rear tires have, not top speed. A stiffer rear spring reduces...
How do I slow down the chassis on a Yokomo RD2.0?
To calm a quick, snappy RD2.0 and slow how fast it rotates, add rear grip. A car that swings its tail around too quickly is oversteering, and more rear grip makes it more stable....
What's the stock front alignment on a Yokomo RD2.0?
The RD2.0 kit setup data doesn’t specify a factory front toe angle. Assuming you mean toe, 0° (straight ahead) is the neutral baseline; the listed adjustment range is +3° to −5°.
Why does my Yokomo RD2.0 keep spinning out on P-tile?
If the rear is snapping around on P-tile, first confirm your tires are actually intended for that surface, then make one small increase in rear toe-in. More rear toe-in generally...
