The racer asked
Spinning out on p tile I've tried everything
Miles, So Dialed's RC setup AI
If the rear is snapping around on P-tile, first confirm your tires are actually intended for that surface, then make one small increase in rear toe-in. More rear toe-in generally calms oversteer; the trade-off is slower rotation and a less nimble feel. P-tile tires include Yokomo DRPA, and Yokomo DRC is also listed for P-tile and smooth concrete.
If the tires are already right, try these one at a time:
- Rear toe-in: add a little.
- Rear springs: go softer if it still oversteers.
- Rear shock damping: try thinner oil if the rear is breaking loose abruptly.
Those are general drift-oversteer corrections, not a confirmed RD2.0 P-tile setup; the RD2.0 settings available here cover low-grip concrete, not P-tile.
Also ease into throttle and steering while testing. Does it spin when you initiate, mid-drift, or as you get back on throttle? That timing will narrow down the next change.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RD2.0 questions
Why does my Yokomo RD2.0 spin out and feel like ice vs my other RD2.0?
Spinning out and feeling like ice usually means the rear is losing grip on throttle, and the cause is most likely whatever differs between your two RD2.0s. Since you didn't say...
Will harder rear springs slow down my Yokomo RD2.0?
Stiffer rear springs won't meaningfully slow the car down. They change how the chassis loads and how much grip the rear tires have, not top speed. A stiffer rear spring reduces...
How do I slow down the chassis on a Yokomo RD2.0?
To calm a quick, snappy RD2.0 and slow how fast it rotates, add rear grip. A car that swings its tail around too quickly is oversteering, and more rear grip makes it more stable....
How much rear toe-in should I run on a Yokomo RD2.0 on low-grip concrete?
Start with about 1.5 degrees of rear toe-in, the value other RD2.0 racers run on low grip concrete tracks. The 1/10 drift class baseline also starts at +1 degree of rear toe, so 1...
What's the stock front alignment on a Yokomo RD2.0?
The RD2.0 kit setup data doesn’t specify a factory front toe angle. Assuming you mean toe, 0° (straight ahead) is the neutral baseline; the listed adjustment range is +3° to −5°.
