The racer asked
low grip astroturf
Miles, So Dialed's RC setup AI
There isn't a public low-grip astroturf setup to copy. The only astroturf setup is medium grip, so I'd start from it and make a few changes toward more traction. Those changes are general guidance for low grip rather than values from a matching setup.
- Ride height: raise it toward 18 to 20 mm, front and rear. The kit is 19 mm, and the low-grip setups I found run 18 mm (clay) and 20 mm (dusty). The rishpon astroturf setup ran 15 mm, which is likely too low for slick low-grip surfaces.
- Diff height: lower it to +0 mm. Lower diff height suits low grip with higher ride height. The kit is +1 mm.
- Slipper clutch: loosen it a little if you run one. Looser absorbs the punch and cuts wheelspin on low-grip surfaces.
- Rear shock oil: try a lighter weight if the rear steps out on corner exit. Lighter oil adds traction.
Change one or two of these at a time so you can tell which one helps. Lowering the diff height and raising ride height together may be enough on their own.
If the car pushes on entry, the next change to try is softer front springs. If it gets loose mid-corner, try softer rear springs. Tell me the track layout (open or tight) and whether the car pushes or gets loose, and I can narrow this down.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RC10 B7.1/B7.1D questions
How can I get more low-speed steering on a Team Associated RC10 B7.1/B7.1D?
For a sharper steering response at low speed, try KPI 3 if you’re currently at KPI 0. The B7 setup tips describe KPI 3 as the most direct steering feel, while KPI 0 is less...
What pill setting for wide C and D blocks on RC10 B7.1/B7.1D?
For a wide rear pivot on the B7.1/B7.1D, set the C- and D-block inserts to the positions that give the widest hinge-pin spacing, and mirror the left and right sides. There isn’t...
Which tires for a freezing-cold track on an Associated RC10 B7.1/B7.1D?
For a freezing-cold track, start with a soft or super-soft compound. Cold tires need a softer compound to conform to the surface and generate grip; the right tread still depends...
RC10 B7.1: 69T vs 72T spur with 17.5T motor — which is better?
A 69T spur gives taller gearing than a 72T spur with the same pinion: about 4.2% more rollout, so it can gain speed on a long straight. It also gives up some wheel torque, which...
Gearing for RC10 B7.1 with Hobbywing V10 G5 17.5T?
For the RC10 B7.1 with the Hobbywing V10 G5 17.5T Torque, start with a 31T pinion and the stock 78T spur. That gives a 6.54:1 final drive ratio; confidence is high for this...
How do I set up a Team Associated RC10 B7.1/B7.1D for a Nor‑Cal track?
Nor-Cal’s name alone doesn’t tell me the surface or grip, so there isn’t one reliable track-specific setup. If you mean a low-grip clay layout, use these B7.1D settings as a...
