The racer asked
pil setting on wide C and D blocks
Miles, So Dialed's RC setup AI
For a wide rear pivot on the B7.1/B7.1D, set the C- and D-block inserts to the positions that give the widest hinge-pin spacing, and mirror the left and right sides. There isn’t one universal pill orientation: the eccentric inserts also change pin height, rear toe, and anti-squat.
The B7 setup guidance describes the inserts as adjustments for those four geometry settings. As a starting point, it recommends 2–3° rear toe-in; the general 2WD buggy baseline is 2° anti-squat. Make sure your pill positions preserve the toe and anti-squat you want, not just the width.
If you mean a specific pill diagram position, tell me whether you’re setting pin width, toe, pin height, or anti-squat, and whether it’s the B7.1 or B7.1D.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More RC10 B7.1/B7.1D questions
What setup changes for a Team Associated RC10 B7.1 on low-grip astroturf?
There isn't a public low-grip astroturf setup to copy. The only astroturf setup is medium grip, so I'd start from it and make a few changes toward more traction. Those changes are...
How can I get more low-speed steering on a Team Associated RC10 B7.1/B7.1D?
For a sharper steering response at low speed, try KPI 3 if you’re currently at KPI 0. The B7 setup tips describe KPI 3 as the most direct steering feel, while KPI 0 is less...
Which tires for a freezing-cold track on an Associated RC10 B7.1/B7.1D?
For a freezing-cold track, start with a soft or super-soft compound. Cold tires need a softer compound to conform to the surface and generate grip; the right tread still depends...
RC10 B7.1: 69T vs 72T spur with 17.5T motor — which is better?
A 69T spur gives taller gearing than a 72T spur with the same pinion: about 4.2% more rollout, so it can gain speed on a long straight. It also gives up some wheel torque, which...
Gearing for RC10 B7.1 with Hobbywing V10 G5 17.5T?
For the RC10 B7.1 with the Hobbywing V10 G5 17.5T Torque, start with a 31T pinion and the stock 78T spur. That gives a 6.54:1 final drive ratio; confidence is high for this...
How do I set up a Team Associated RC10 B7.1/B7.1D for a Nor‑Cal track?
Nor-Cal’s name alone doesn’t tell me the surface or grip, so there isn’t one reliable track-specific setup. If you mean a low-grip clay layout, use these B7.1D settings as a...
