The racer asked
i have understeer at corner entry off power, but when i apply push brake i get snappy oversteer on corner entry or middle corner
Miles, So Dialed's RC setup AI
First reduce the brake strength in the ESC or radio, then test again. The sudden oversteer under push brake suggests the rear is losing grip when braking; changing the suspension to add more entry rotation could make that worse.
- Reduce the ESC’s maximum brake or radio brake EPA a small step, and use a smoother brake curve if available. Brake progressively rather than applying it abruptly.
- If it still snaps, reduce brake strength another small step. Check whether the rear tires are skidding or locking when it happens.
- Once braking is predictable, address the off-power entry push separately. A softer front anti-roll bar can help the R1B turn in, but make that one change at a time and watch for the rear becoming too loose. The R1B’s available front anti-roll bar options include 0.8 to 1.2 mm. General off-road setup guidance also points to a lighter front anti-roll bar for entry understeer.
If the car still pushes while coasting but only snaps when you brake, keep those two symptoms separate: first make braking stable, then tune the front end for more off-power steering. What surface are you racing on, and what brake setting are you using now?
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More R1B Mark 1 questions
How do I raise or lower front hub height on an R1WURKS R1B Mark 1?
On the R1WURKS R1B Mark 1, front hub height is adjusted with steering-block shims. The available setup data lists shim options from 0 to 3.5 mm, but it does not specify a reliable...
What's the best setup for high-bite carpet on R1WURKS R1B Mark 1?
For a high-bite carpet baseline on the R1WURKS R1B Mark 1, start with Pink-compound tires, a 1.1 mm front anti-roll bar, and a 1.4 mm rear anti-roll bar. These settings come from...
