The racer asked
Raising or lowering front hub height
Miles, So Dialed's RC setup AI
On the R1WURKS R1B Mark 1, front hub height is adjusted with steering-block shims. The available setup data lists shim options from 0 to 3.5 mm, but it does not specify a reliable handling direction for raising versus lowering, so make a small change and test rather than assuming it will add or reduce steering.
This adjustment changes the front axle’s height relative to the steering block, which alters front-end geometry. It is not the same as changing front ride height. Other R1B setups use 3.5 mm on carpet and 2 mm on astroturf, useful reference points rather than universal targets.
- Keep the left and right shim settings equal.
- Change one step at a time, then check front ride height, camber, and toe.
- Compare turn-in and mid-corner grip over several laps before changing another setting.
If you share the track surface and whether you want more or less steering, I can suggest which direction to test first.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More R1B Mark 1 questions
Why does my R1B Mark 1 understeer on entry but snap into oversteer with push brake?
First reduce the brake strength in the ESC or radio, then test again. The sudden oversteer under push brake suggests the rear is losing grip when braking; changing the suspension...
What's the best setup for high-bite carpet on R1WURKS R1B Mark 1?
For a high-bite carpet baseline on the R1WURKS R1B Mark 1, start with Pink-compound tires, a 1.1 mm front anti-roll bar, and a 1.4 mm rear anti-roll bar. These settings come from...
