The racer asked
I’ve just built an mp11e kit and the ride heights you give for base are not achievable, the lowest I can get on the rear is 33
Miles, So Dialed's RC setup AI
I haven't given you ride heights earlier in this chat, so I'll go by the class baseline and what other MP11e racers ran. For a 1/8 scale 4WD buggy on dirt/clay, the typical starting value is 23 mm front and 26 mm rear. Other racers on the MP11e ran 25 mm front and 28 mm rear, so a 33 mm rear is well above both.
To lower the rear, change these one at a time:
- Rear Suspension: Axle height: move from High to Low. The kit is High, and other racers ran Low.
- Rear Suspension: Shocks: tower mounts: move from Mid-in to In. Other racers ran In.
- Rear shock length: shorten it to bring the rear down. Other racers ran 119 mm.
Axle height and the tower mount lower the chassis at the rear without changing spring rates. Lowering the rear also shifts the car toward understeer (push), so if it starts pushing on corner entry, check the front ride height next and move it down a little.
If you tell me your front ride height and which of these settings you've already changed, I can suggest the next step.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
More Inferno MP11e questions
What shock oil weight for front and rear on Kyosho Inferno MP11e on astro?
For a Kyosho Inferno MP11e, start with 500 cSt front and 550 cSt rear on astro, assuming the kit-baseline setup. Those are the model’s listed starting values; I don’t have a...
What is a good baseline setup for a Kyosho Inferno MP11e?
Assuming you’re running the Kyosho Inferno MP11e on dirt or clay, use this 1/8-scale 4WD buggy baseline: 23 mm front and 26 mm rear ride height, -3° front and -2° rear camber, 1°...
