The racer asked
what should i do for setup on a high banked concrete oval
Miles, So Dialed's RC setup AI
For your Traxxas Slash Late Model, start with the 1/10-scale Late Model oval baseline, then make it more controlled for the high-grip concrete. I don’t have a specific tested setup for this exact car on a high-banked concrete oval, so treat these as starting settings, not a guaranteed final tune.
- Ride height: 15 mm front, 21 mm rear.
- Camber: RF -3°, LF -1°, LR +2°, RR -2°. Front toe: 0.5° out. Front caster: 5°.
- Weight: 55% rear, 55% left, with 52% wedge, if you can measure and adjust those values.
High grip loads the suspension hard, and banking adds sustained side load. To limit excessive roll, use stiffer springs or a thicker anti-roll bar, and keep the chassis from bottoming or rubbing. The Slash Late Model has front and rear anti-roll bar options; increase bar stiffness gradually rather than making a large jump. Higher roll center and less suspension droop can also help calm chassis roll.
Watch whether the car pushes through the center or gets loose on exit. Change one thing at a time: if it rolls or feels lazy, try a small increase in bar stiffness; if it loses grip or skips over the concrete, back that change off. Check tire grip and wear before chasing suspension settings.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
