The racer asked
What should my toe/steering rods be set to rod end to rod end
Miles, So Dialed's RC setup AI
There isn’t a verified rod-end-to-rod-end length available for the TLR 8IGHT-XE 2.0, so I wouldn’t guess a measurement. Set the front toe by the wheels’ angle instead: a reasonable 1/8 4WD buggy baseline is 1° front toe-out.
Center the servo and steering, make the steering links the same length as a starting point, then use a toe gauge to adjust until both front wheels have the same toe-out. The exact link length can vary with rod ends and steering geometry. More toe-out can help the car turn in, but too much can make it less stable on the straight.
Follow-up
I'm running 7-5-3 diff oils for revelation Raceway Montclair ca dusty slippery loose track
Miles
Assuming you mean 7,000/5,000/3,000 cSt, that’s a reasonable low-grip direction for your dusty, slippery track. Your front and center match the TLR 8IGHT-XE 2.0 reference settings; your 3,000 rear is a little thinner than the listed 4,000 baseline and common 4,000–5,000 range.
I’d keep the 7-5-3 if the car feels planted and drives forward well. If the rear feels too loose or inconsistent under power, try changing only the rear to 4,000. If you tell me what the car is doing in the turns, I can suggest whether to change the oils or another setting.
Follow-up
I was previ running 10-10-5 and it was constantly washing out entering turns and very loose exiting them fishtailing on straights
Miles
That mix of symptoms suggests the 10-10-5 was too locked in the center for easy rotation, while the 7-5-3 may now be too loose at the rear. For the TLR 8IGHT-XE 2.0, the reference is 7,000/5,000/4,000 cSt front/center/rear, with the rear commonly run at 4,000–5,000 cSt.
Try raising only the rear diff from 3,000 to 4,000 cSt first. Thicker rear fluid gives more traction and stability on power; thinner rear fluid allows more rotation but reduces side bite. The 3,000 rear could contribute to the exit fishtailing, especially on a loose surface.
Keep the 7,000 front and 5,000 center for that test. Compared with your old setup, the thinner center should make the car easier to rotate, while the thinner front may reduce entry bite. If it still washes out on entry after the rear change, the front diff or another steering/grip setting may need attention. Make one change at a time, and note whether the problem happens off-throttle, on-throttle, or both.
Follow-up
I don't have 4 diff oils only 3 and 5
Miles
That’s fine. Since you’re fishtailing on the straights and loose on corner exit, try 5,000 cSt in the rear diff and keep the front at 7,000 and center at 5,000. That makes your setup 7-5-5.
The TLR 8IGHT-XE 2.0 reference is 4,000 cSt rear, with most racers using 4,000–5,000 cSt, so 5,000 is a suitable option and 3,000 is below that range. Thicker rear fluid should add rear traction and stability under power; the trade-off is that it may reduce some on-power rotation. Test this single change first and see whether the straight-line fishtailing improves.
Answered by Miles, our RC setup AI. Check anything that affects safety or fitment against your manual.
